Half lengthways, with the wrong sides on the inside. You’ll need two strips up to 78cm long depending on the size you’re making, there will probably be a little leftover to trim off.Fold the two strips of bias binding in Secure the facing to the shoulder seam allowance with a few small hand stitches.įrom dress fabric, make strips of bias binding for your hem. Understitch the facing around the neckline, sewing only through the facing and the seam allowance. Press both the facing and the seam allowance away from the body of the dress. Clip around the neckline curve to allow it to sit flat when turned right side out. Lay the facing right side down on top, matching up the raw edges of the neckline and the shoulder seams. Lay the dress flat, with the right side facing up. Neaten the seam allowances and press the seams open.Neaten the lower edge of the facing with a zig zag stitch or an overlocker. With right sides together, pin the facings at the shoulder seams. If using, apply fusible interfacing to the front and back neck facings. Neaten the seam allowances and press the seams open. With right sides facing, pin the front and back together at the shoulder seams. Pin and sew the bust darts on the front piece. There are different front facings depending whether you’re making the high or V-neck option. Using the cutting guide, cut all the pieces from fabric. Trace the pattern from your pattern sheet onto dressmaker’s tissue paper, transferring all the markings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |